The Mutts Nuts
400ml Aerosol Advanced lubricant and freeing agent
Unique, highly efficient, versatile and effective lubricant/penetrating product, which incorporates the latest anti-friction/anti-wear technology, ceramic reinforced PTFE.
Providing the ultimate in lubricating performance in any industrial environment, from heavy plant to golf courses.
The Mutts Nuts rapidly combats moisture and corrosion, leaving a clean and lubricated surface. Use as a lubricant on chains, wire ropes, slides and guides, small bearings etc. and as a superb release agent for even heavily corroded and/or seized components. MN101 offers superb protection as an assembly lubricant allowing newly assembled machine parts to resist weathering galling and seizure for greatly extended periods. Highly recommended for mining and/or off shore oil and marine applications.
Lubricates a wide variety of moving parts including chains, wire rope, slides, guides, small bearings etc.Frees corroded and seized parts, penetrating even heavy corrosion quickly and easilyDisplaces moisture and dries metal surfaces depositing a rust inhibiting film on all metalsWill not damage delicate rubber, plastic or decorated/painted metal.
One versatile product for a multitude of uses
Allows dismantling of even severely corroded parts saving time and money
Inhibits corrosion on all metals, will not damage decorative finishes
Lubricates even the most delicate of components
Penetrates deeply into hard to reach areas
Effective formulation means reduced product usage
MN 101 offers exceptionally low coefficient of friction; high levels of wear protection wide operating temperature range (-40 to 280°C), is non-toxic and odour free.
TYPICAL PHYSICAL CHARACTERISTICS OF MN 101 (after evaporation of propellant)
Flash Point closed cup (°C) ASTM D 93
Kinematic viscosity ( mm²/sec ) @ 40°C NFT 60-100
% Evaporation (20°C) + 24h
% Evaporation (20°C) + 48h
Dry extract 120°C / 1 hour (%)
% Active Ingredients
Temperature of use ( ° C )
Diffusion (20°C) (mm)
Salt spray test ASTM B117
Resistivity (k ohms at 25°C) Ransburg Cell Type
Surface tension (mJ/m² at 25°C) NF ISO 304
Sedimentation after 24 h (%)
Test 4 ball extreme pressure (kg) ASTM D 2783
Test 4 ball wear (mm) ASTM D 4172
Static friction coefficient Sliding angle test
Residues aspects after drying on metal and on
Legal labelling 2001/59/CE
Labelling on the container 2001/59/CE
-40 TO 280 °C
> 200 hours